Hi Coen,
a couple of weeks ago I tried W10-10074 and installed the driver 1.03 and faced the same problem ( sample rate moving along all rates in a loop and never stops). The installation of 1.04 failed on that build.
With build 10240 the driver 1.04 installation suceeded and is stable as a rock.
Joachim
Hmmm,
Started the PC and no NOS1a in the driver panel appeared. Rebooted and it appeared again.
Saw the sample rate moving along all rates in a loop.
After starting XX and playing a track and the error message "failed to set sample rate" appeared. After two tries the music started playing. Imho this is about "catching" the right sample rate in the loop.
Now the music played, but shoot me I think it sounded pretty cr*p compared to the other day. Also later in the track there seem to be hiccups in the music. I also saw some kernel streaming errors.
regards, Coen
p.s. the was in normal OS mode still.
I faced the same problem then i installed Win10 - 10074.
My solution: Onboard HD Audio must be enabled in bios during installation of Win10 - 10074.
I first installed 10074 with Onboard HD Audio disabled in bios. No audio driver active. After installing the Phasure usb-driver I got the same problems as quoted above.
After several attempts i tried to enable the Onboard HD Audio in the bios. I then installed 10074. Standard audio drivers for audio was automatically installed. After this i installed the Phasure usb-driver and all worked fine.
Maybe there must be an audiodriver up and working in 10074 before the Phasure USB-driver can be properly installed?
Harald
Show Posts
