|
Title: Can't see Q sliders under Post by: SeVeReD on January 25, 2009, 08:55:45 pm Under Qcontrol tab
I can't see the sliders. I can see the headings Q1=14 (then about a half inch space) Q2=0 Q3=0 Q4=0 Q5=0 (Q2-Q5 all have the same small space) but not the sliders... except Q5 slider is way to the bottom right. EDIT Also, when I mouse over the blank areas of Qcontrol panel the Q settings of Q1 Q4 and Q5 show up as a tooltip... but I can't see the sliders... I've tried a couple different resolutions ...doesn't change. fyi native resolution is 1440*900 60hz EDIT2 (side note) for as long as I can remember the "Processor Core Appointment Scheme" selection box cuts off the beginning of the selection (ie half of the S in "Scheme 3" doesn't show, and if I was to choose "No appointment" it shows up as pointment in the box) Title: Re: Can't see Q sliders under Post by: PeterSt on January 25, 2009, 09:54:38 pm Huh ? would you care to show pics of this ?
Also show a picture of the volume slider please. This one is even smaller. Thanks. Title: Re: Can't see Q sliders under Post by: PeterSt on January 25, 2009, 10:45:56 pm Anyway ... I've made the sliders as large as they were before.
In original download (http://www.phasure.com/index.php?topic=712.0) a XXHighEnd-0.9-w9a.zip is obtained now for that. Currently, the XXHighEnd-09-w9.zip in there contains the adjustment too (and shows as 0.9w-9a). Edit : Above is not true anymore. See my next post below. Title: Re: Can't see Q sliders under Post by: SeVeReD on January 25, 2009, 11:49:29 pm Here it is from W9
Will try W9a after lunch Title: Re: Can't see Q sliders under Post by: PeterSt on January 26, 2009, 12:19:56 am Ah, now I see ! This happens at resizing the middle pane.
Here is a full new version now : XXHighEnd Model 0.9w-9b (solves Q parameter dislocation) (http://www.phasure.com/index.php?topic=715.0) Sorry for the inconveniency. |